The introduction of a two-layer membrane-covering technique in garlic has the effect of increasing production, early marketing and efficiency. Here's a little bit about garlic diaphragm technology。
I. Garlic diaphragm technology
The membrane requires that the membrane be flattened without wrinkles, and that there be no gaps under the membrane, so that the membrane is attached to the membrane so as not to breed weeds. When garlic is produced more than 50 per cent of its seedlings, the defaced membranes are perforated by sharp wire and the diameter of the mouth is around 1 cm。
Ii. Elements for the strengthening technology of ground ground
1. Selection of garlic
The choice is for varieties with large petals, high yields, short hibernation periods, seedlings and fast growth. Cultivation is generally carried out in the spring and autumn。
2. Preparation for transmission
The choice is for varieties with large petals, high yields, short hibernation periods, seedlings and fast growth. Inflating garlic with 30°c-50°c of hot water for about 30 hours. Then the asphalt pile was suffocated for about 12 hours and the garlic was dug. If the sowing area is large and soaks are high, it can also be sowed one week in advance without digging。
3. Garlic pressure on soil
Each square metre is about 15 kilos of garlic, and the tighter the distance between garlic and garlic, the bigger the gap is filled with smaller garlic. When the garlic petals are set up, three centimetres thick of sand is covered with sand and the surface is sprayed with 600 times the new high lipid membrane to increase the yield rate。
4. Water management
A new high fat membrane dilution at temperatures not less than 15°c is used to water garlic seedlings, plant them and water them up to the pre-growth stage, medium-term watering them up to about 15 cm, and small water at the end of the three to four days before harvesting. The frequency of water is dependent on the dry wetting of the soil on the shelf bed。
5. Temperature light
It is important to keep the laminates clean and to improve light visibility in order to gain more light time. The application of luminous filaments can help garlic seedlings to absorb large amounts of light energy and combine nutrients with conventional fertilizers to make garlic seedlings grow better。
6. Timely harvesting
When garlic is grown to about 35 centimetres and leaves are slightly tilted, harvesting should be timely. After harvesting, new garlic seedlings can grow 20 days later using the same management methods described above. When new garlic seed is up to about 30 cm, it can be harvested and sold again. Such recycling management and harvesting can be followed by a continuum of 3-4 per cent。
Garlic is not difficult to grow and can grow everywhere, and produces good quality. Large-scale planting, such as in the shandong riang, is economically beneficial。
