How to increase the production of barley? Wheat is a vegetable species imported from abroad and cultivated in many parts of the country. It is rich in nutrients and delicious leaves. Today, many of you will present some of the technical aspects of growing the vegetables
1. Scientific seeding
In mid-september, seeds are usually sowed with suitable grains of sand and seeds, separated and then planted. Be careful not to broadcast it in case it's the baby。
Seeds can generally be covered with 0. 5 cm thick of thiophos-methyl mixed with thiophos-methyl。
The seedlings are separated when they grow two leaves, with a transplant density of 6 cm x 6 cm. The seedbeds are kept wet and need to cover the sun at noon. Pest and disease prevention in the nursery period。
2. Deep soils
Wheat is not deep, but the surface soil is grown over the years, and the nutrients of the soil are lower than those of the deep, which, in addition to being undamaged, accumulates long nutrients。
Deep soil is to provide a better soil environment for the barley, which grows at a very fast pace and matures in a short period of two months, so that its development must be ensured with better trophic soil. So the first thing to do is to dig deep, about 15 centimetres deeper than usual。
3. Extra fertilizer
Wheat can be properly followed up for about 10 days, fertilized quickly and not at too high a concentration, best with decomposition and urine. On the basis of organic fertilizer application, nitrogen fertilization can be followed up with water in small quantities, 2-3 times at 5-10 kg per acre。
In about 10 days after planting, a leaf fertilisation can begin once, with 0. 3 per cent of potassium phosphate and a mixture of urea, and three to four leaf fertilizers over the entire lifetime, once every 7 to 10 days。
It would be preferable to stop watering and fertilizer some five days before the harvest, so that the plant is not too young, less water content and better quality。
Control density
The demand for a single barley is relatively high, so the pursuit of high density is not a high-yielding method and can only lead to undesirable growth, and reasonable planting density is a major contributor to high-yielding production。
The density is based on the local aquatic nutrient environment, with a good soil fertility, with a range of 10-15 cm and a low fertility distance of 15-20 cm. Each length is controlled at approximately 1. 2 metres, with a drainage ditch of about 20 centimetres reserved for the middle。
5. Keep water
Experienced growers know that the production of wheat and wheat in water fields is much higher than in drylands. And the article begins by telling you that the water share of vegetables is high, so that the demand for moisture is high, and the drainage ditches mentioned above can also be used for water。
The moisture in the field is expected to keep the soil wet in the long term, while a small amount of water is present in the drains, so that a wet growing environment can be built for the wheat and leaves can grow much faster and have high yield。
