It is the first time that plant plants are planted in a flower basin. The following are the operational steps in the science of pellets:
Step 1: select the flower basin, pre-treatment。
Before entering the basin, the appropriate flower basin is selected according to the size and growth of the plant. If the old basin is to be washed, then disinfected and tanned, then used; if the new basin is to be immersed for one to two days to remove dryness and alkaline。
Step two: brush drain, do drain。
The vent vents are used to drain air, and the two mini-walls are placed in human form on the vents, i. E. Half of the vents are covered with one piece and half of the other is placed on the first piece of debris, thus preventing soil congestion. For flowers that are afraid of flooding, air penetration, drainage and rooting should be increased by 1-4 centimetre-heavy shreds or coarse grains, coal residues, etc. On the bottom of the basin。
Step three: fill the soil and plant it。
When filling the soil, it is to be filled in two parts, starting with a layer of subsoil on the drain, the thickness of which depends on the depth of the basin and the size of the plant. The soil is normally filled to the depth of the plant. And the stem and the root shall be strong, and they shall be deep, and the root and the root shall not be too deep in flesh. The upper part of the basin must have water mouths, which are shallow, based on the usual permeation of water at the bottom of the basin。
The naked seeder should pile up the ground into a puddle of the basin heart, with one hand putting the tree straight and the roots wide open, and the other hand filling the soil with a light lifting of the tree, so that the roots can stretch below the corner of 45°c. Long roots of flowers are required and, when entering the basin, the trees can be rotated so that the roots are evenly synchronized in the basin. And when any flower is in the basin, it must be solid, not empty or empty. Use hand-by-hand pressure to hold down, easily to the root。
Step four: cover the sun properly and pour water again。
Put it in a warm and sunshield and pour water once. The way to judge is to see the water in the bottom flow hole. After a few days, the light is gradually lighted and normal management takes place. After about seven days, they will be moved to the sun-filled areas or under the shades for normal day-to-day management。
- - - - - - - - -
Knowledge of flower breeding
