Dude, have you noticed that there are places in the fish tank where water doesn't seem to be moving much, where fish dung don't move? That's the dead water zone. Water is not flowing in the dead water zone, where fish dung is corrupted and nitrogen is produced. Old fish taught you to find the dead water in the tank today。
What's the danger of a dead water zone
The water is not moving, fish dung bait is stored there, and bacteria breed in large quantities. Nitrogen nitrate in the water surges locally, and fish are not comfortable swimming there. In the long run, dead water areas become “toxic zones” and fish are prone to disease. Dirty things in the dead water can slowly release toxins and contaminate the whole tank。
Where is the dead water zone
The corner of the fish tank is the most common, especially the opposite position, and the flow is difficult to reach. The back of the water exit is also a dead corner, and the direction in which the water flows directly creates the water-flow blind zone. The bottom of the tank is also a high-prevalence zone in the dead water zone, especially behind sands and scenery. There may also be a dead water zone at the bottom of the big tub。
How do we find the deadwater zone
The simplest way to feed and observe is to throw a little feed and see where the current brings it. The area where the feed doesn't go is the dead water zone. Put a little shrimp meat or fish grain and see where it floats into the water and stops in the dead zone. Watch the fish dung and see where it's easy to build. Tie a feather with a thin wire, put it in different positions, see if it's still moving, or if it's still alive。
Old fish's flying feathers is the most practical
Take a line and a feather, tie the feathers online and put them in different positions in the tank. Plumb movement indicates a current and the plume remains a dead water zone. This method does not contaminate water quality and is readily detectable。
How do we eliminate the dead water zone
Reorienting the water is the first step towards the dead zone. A wave pump is added and placed near the dead water zone, which runs for 10-20 minutes a day. Reposition the vent to cover the whole tank. Add a rock, and bubbles can drive the current。
How do different fish tanks eliminate dead water
Bottom filtration tanks are most prone to dead water zones, with a concentration of water coming out of the mouth, and a lot of dead ends. It's the best thing to do with a wave pump. Go to the filtration tank, re-direct the water mouth, and let the water slide to the bottom. The casks, the casks are stylish, and the dead ends are stylished, pumped or repositioned。
Let's get this straight
The dead water zone is a danger to the fish tank, and it is recommended that it be measured monthly to see if there are any new dead ends. Flying plum is the simplest, free of charge and free of pollution of water quality. The elimination of dead water zones, the production of wave pumps and the adjustment of water vents are the most common methods. Dead water zones have been eliminated and the quality of water has stabilized considerably. Have you tried to find a dead water zone? The comment section talks to fish。
Old fish said that many people did not know about the dead water zone, but it was the source of many water quality problems. Old fish also changed the bottom filtration to find out about this problem. The freshman's friend uses flying plumes to reposition the water。
